Table of Contents
Advertisement
Cable Management Tray Summary
The cable management tray is attached to the bottom of the chassis, and routes the
cables down below the chassis, or out the sides of the chassis.
Time and Items
Time and items required to replace the cable management tray include:
Replacing the Cable Management Tray
Use this procedure to remove and install a cable management tray.
1. Obtain a #2 Phillips head screwdriver.
2. Uninstall the current cable management tray, as follows.
3. Install the new cable management tray, as follows.
Core Switch 2/64 V4.1 Installation Guide
Time required: Less than 5 minutes
Items required: #2 Phillips screwdriver
WARNING:
Do not use a power screwdriver on the cable management tray.
a. Pull any cables out of the tray.
b. Unscrew the two screws holding the tray to the chassis, and put aside in a
safe place.
c. Rotate the front of the tray down, then lift the back to disengage the tabs
on the back from the chassis.
a. Orient tray as shown in
tray into the two slots at the bottom of the AC panel, then rotate front of
tray upward until it locks into place.
Figure
45, and insert the two tabs on underside of
chassis.
Installing Core Switch 2/64 FRUs
159
Advertisement
Table of Contents
