Powering On For The First Time; Installing The Power Cord Retainers - HP AA-RS2WC-TE Installation Manual

Powering On for the First Time

Use these steps to install the power cord retainers, and apply power to the Core
Switch 2/64.

Installing the Power Cord Retainers

HP provides two power cord retainers to hold the AC power cords in place.
Phillips screws (#4-40) are included. A #1 Phillips screwdriver is a required tool.
Use these steps to attach each power cord retainer onto the AC power inlets.
1. Orient each power retainer as shown in
2. Loosen the adjusting screws on either side of the power inlets to allow the
3. Position the power cord retainer tabs under the two screws on either side of a
.
1
2
Figure 18: Installing power cord retainers
Core Switch 2/64 V4.1 Installation Guide
power cord to fit into the retainer.
power connector on the chassis, see
with right and left bends.
Installing and Configuring the Core Switch 2/64
Figure 18.
Figure 18. The power cords are designed
Left power cord
1
retainer
Right power cord
2
retainer
SHR-2530A
67