Table of Contents
Advertisement
Figure 32: Logging in to switch 0 from a serial console, then failing over
5. Enter the version command to record the version of the active CP card.
6. Enter the hadisable command from the active CP card to prevent failover
7. From the serial console for the healthy (and active) CP card, back up the
8. Enter the configupload command.
9. Enter the requested information at the prompts.
Core Switch 2/64 V4.1 Installation Guide
Fabric OS (cp1)
cp1 Console Login: admin
Password:
Enter Switch Number to Login <0 or 1>: 0
SW0:admin> hashow
Local CP (Slot 6, CP1) : Active
Remote CP (Slot 5, CP0) : Standby
HA Enabled, Heartbeat Up
SW0:admin>
SW0:admin> hafailover
Warning: This command is being run on a control processor(CP)
based system and will cause the active CP to reset. This will
cause disruption to devices attached to both switch 0 and switch 1
and will require that existing telnet sessions be restarted.
To just reboot a logical switch on this system, use command
switchreboot(1M) on the logical switch you intend to reboot.
Are you sure you want to reboot the active CP [y/n]? y
SW0:admin>
SW0:admin> hashow
Local CP (Slot 6, CP1) : Standby, Healthy
Remote CP (Slot 5, CP0) : Active
HA Enabled, Heartbeat Up
SW0:admin>
or communication between the CP cards during the replacement.
current configuration for logical Switch 0 (see
This command uploads the switch configuration to a specified FTP server.
Installing Core Switch 2/64 FRUs
Figure
33):
137
Advertisement
Table of Contents
