Installing and Configuring the Core Switch 2/64
Preset Configuration Settings
The Core Switch 2/64 ships with the following factory installed settings:
74
Caution:
Resetting a logical IP address while the switch is running in the
fabric may cause Web Tools, Fabric Watch, SNMP, and other applications to
terminate.
General system parameters (modifiable through the configure
command).
WWNs for both logical switches: The two WWNs are not modifiable; both
are pre-configured and are usually based on the chassis serial number.
Domain ID: The default domain ID for both logical switches is 1.
One domain ID for any 16-port cards in slots 1-4, and one for any 16-port
cards in slots 7-10 (domain IDs can be modified through the configure
command)
A native IP address, host name, subnet mask, and gateway address for both
CP card slots (modifiable through the ipAddrSet command).
Logical IP addresses: A logical IP address and subnet mask for both logical
switches (modifiable through the ipAddrSet command).
Switch names for both logical switches (modifiable through the
switchname command).
Switch status policies (modifiable through the switchstatusploicyset
command).
Core PID setting (modifiable through the configure command).
Core Switch 2/64 V4.1 Installation Guide