Table of Contents
Advertisement
Operating the Core Switch 2/64
Interpreting POST Results
Each time the switch is powered on or reset, the switch automatically performs
POST, a system check during which LED patterns may vary.
To verify that POST completed without errors:
116
Verify that all LEDs return to a normal state after POST is complete. Use the
slotShow command to check the status of the slots.
Verify that the switch prompt displays when POST completes. If it does not
display, POST was not successfully completed. Contact HP support.
Review the system log. Any errors detected during POST are written to the
system log, accessible through the errShow command.
Core Switch 2/64 V4.1 Installation Guide
Advertisement
Table of Contents
