Table of Contents
Advertisement
Operating the Core Switch 2/64
Powering the Core Switch 2/64 On and Off
Note:
for the First Time
To power on the Core Switch 2/64:
1. Verify both power cords are connected to the AC power connectors on the
2. Flip both green AC power switches to 1. The green AC power switches
To power off the Core Switch 2/64:
1. Flip both AC power switches to 0.
2. To remove all sources of power from the switch, disconnect both cables from
Note:
restored, all devices are returned to the initial state and the switch runs POST.
90
To provide power to the switch for the first time, see the section
on page 67 in
front of the chassis.
illuminate.
Caution:
Allow the Core Switch 2/64 to run for a minimum of 10 minutes
after powering on to ensure the switch has fully booted before powering off
again.
the power source.
Removing all power from the switch triggers a system reset. When power is
Chapter
2.
Core Switch 2/64 V4.1 Installation Guide
Powering On
Advertisement
Table of Contents
