Time and Items
Time and items required to replace a filler panel or 16-port card are:
Replacing a Filler Panel or 16-port Card
Use these steps to replace a filler panel or 16-port card.
Note:
and one without.
1. Remove the filler pane (see
Note:
has a grounding connection above the power connectors. Hold the port card by the
edges of the metal pan (do not hold by the ejectors).
Core Switch 2/64 V4.1 Installation Guide
Time required: Less than 10 minutes.
Items required:
— ESD (electrostatic discharge) grounding strap
— Workstation computer
There are two versions of the Port Card Filler Panel: one with ejector handles
You should wear a grounded ESD strap when handling a port card. The chassis
a. Push in the yellow buttons on each ejector.
b. Lift both ejector handles all the way open.
c. If the filler panel does not have ejector handles, pull on the handle in the
middle of the panel.
d. Slide the filler panel out of the chassis.
Figure
27):
Installing Core Switch 2/64 FRUs
127