Installing The Tinnerman Clips - HP StorageWorks SAN Switch 2/32 Installation Manual

Installing the SAN Switch 2/32
4. Install (2) M5 U-type Tinnerman clips for each of the front columns of the rack in
the top and bottom positions of the three-hole EIA pattern as shown in Figure 2–7.
Figure 2–7: Installing the tinnerman clips
5. Assemble the outer rails by completing the following steps:
a. As an aid in assembly, two rubber washers have been included to help keep
the rear slotted portion of the outer rail flush against the rear rail-tray brackets.
Install them as shown in Figure 2–8.
b. Insert the alignment pins attached to the outer rail front flange into the center
opening in the rack.
2–18
SHR-2582A
SAN switch 2/32 version 4.0.x installation guide