Table of Contents
Advertisement
Modifying Domain IDs
Use these steps to modify the domain IDs, if desired. This is an optional
procedure.
1. To view a list of the current domain IDs, open a a telnet session, and type
Note:
make the domain IDs unique before connecting the switches to the fabric.
2. Enter the
3. Enter the
4. Enter Y after the Fabric parameters prompt.
5. Enter a unique domain ID.
6. Follow the remaining onscreen prompts, (or press CTRL+D to accept the
7. Enter the switchEnable command to enable the switch.
8. Before connecting the Core Switch 2/64 to the fabric, verify that all the
Specify Custom Status Policies
Use these steps to specify custom status policies, if desired. This is an optional
procedure.
1. To access the status policy, enter the following command at the prompt:
2. Follow the onscreen prompts to specify the status policies.
3. To completely deactivate the alarm for a particular condition, enter 0 at the
Core Switch 2/64 V4.1 Installation Guide
fabricShow.
The default domain ID for both switches is "1". To prevent a domain ID conflict,
switchDisable
configure
Domain: (1..239) [1] 3
default settings and exit).
switches in the fabric use the correct PID settings. If the fabric will include
switches running versions of Fabric OS that are earlier than 4.1, those
switches must have the Core PID set to 1 in order to join a fabric with
switches running Fabric OS v4.0 or later. For information on setting the Core
PID, refer to the HP StorageWorks Fabric OS Procedures Version 3.1.x/4.1.x
User Guide.
switchStatusPolicySet
prompt for that condition.
Installing and Configuring the Core Switch 2/64
command to disable the switch.
command.
81
Advertisement
Table of Contents
