Replacing the WWN Card
The WWN card is located on the non-port side of the chassis, underneath the
WWN bezel.
Before replacing the WWN card, verify the necessity of the replacement with the
switch support personnel. The Core Switch 2/64 WWN card is highly reliable and
contains redundant components. In the unlikely event that the WWN card does
fail, the Core Switch 2/64 can continue operating due to the high availability
design until the WWN card is replaced, provided the Core Switch 2/64 does not
go through a power cycle.
If a replacement WWN card is ordered, replacement instructions are provided
with the new card.
For Fabric OS v4.0.2 and earlier, replacing the WWN card requires root access to
the Core Switch 2/64. In addition, all software license keys must be replaced when
a new WWN card is installed.
Note:
by screws, and the other is held onto the chassis by the pressure of the bezel against a
pad on the card face.
Core Switch 2/64 V4.1 Installation Guide
Caution:
If the WWN card fails, do not remove it until the replacement card
has been received, and follow the instructions provided with the replacement.
There are two possible versions of the WWN card; one attaches to the chassis
WARNING:
Do not reboot the switch while the WWN card is uninstalled, as
this can cause the switch to boot incorrectly.
Caution:
Wear a grounded ESD strap when handling a WWN card. A
grounding connection is available on the chassis above the power
connectors.
Installing Core Switch 2/64 FRUs
161