Ransomes Matador 71 Safety And Operation Manual page 27

STORAGE
• The machine should be thoroughly cleaned
down to remove all accumulations of grass
clippings and debris.
• Lightly oil the cutting cylinder knives to
prevent rusting. Empty the fuel tank, turn off
fuel tap.
• Run the engine until all fuel in the carburettor
has been used up, clean filter bowl and tap.
Whilst engine is still warm , drain crankcase
and refill with fresh engine oil. Remove spark
plug and pour in approximately 5cc of anti-
corrosive oil. Turn engine over manually a few
times to spread oil over the cylinder walls and
replace the spark plug. Turn engine over
slowly until resistance is felt. This will ensure
both valves are fully closed to prevent
moisture entering. Cover engine, oil all pivot
points, adjusting screws and drive chains.
GENERAL ADVICE
If any damage is apparent when delivery is made, report
the details at once to the supplier of the machine.
After the first few hours of use the machine should be
checked to see that all nuts and bolts are tight.
Before cutting make sure the area to be cut is free from
stones, etc. as these may well damage the cutting
cylinder.
Do not put the mower away with grass cuttings left in
the box.
After using the machine apply oil with a brush to all the
cutters to prevent rusting. When using a hose to clean
the machine, do not direct onto the bearings or the
engine.
GB
GB-25