Appendix A System Messages; System Messages; Alarms And Event System Messages - Symmetricom TimeProvider 100 User Manual

Appendix A System Messages

In This Appendix

System Messages


System Messages
Table A-1 provides information about the alarm and event messages that display in
response to an occurrence of an event or an alarm. The CLI command,
alarmconf
transient if desired. See
Table A-1. Alarms and Event System Messages
Alarm
Number
MB_5.5V
0
MB_1.2V
1
MB_3.3V
2
MB_5V
3
MB_1.8V
4
10MHZ_LOS
5
GPS_ENGINE
6
TM_EFC
7
TM_SELFTEST
8
TM_COMM
9
098-00106-000 Revision A – March, 2009
is used to alter delay, enable state, or define alarm severity and
set alarmconf, on page 71 for more information.
Name Description
5.5V out of range
1.2V out of range
3.3V out of range
5V out of range
1.8V out of range
10MHZ signal loss
GPS engine com-
munication failed or
1PPS missing
RTE PLL tuning
saturated
RTE self test failed
MB-TM communi-
cation failure
Severity
Corrective Action
Level
Reboot. If problem per-
Major
sists, return to factory.
Reboot. If problem per-
Major
sists, return to factory.
Reboot. If problem per-
Major
sists, return to factory.
Reboot. If problem per-
Major
sists, return to factory.
Reboot. If problem per-
Major
sists, return to factory.
Reboot. If problem per-
Major
sists, return to factory.
Reboot. If problem per-
Major
sists, return to factory.
Check ambient temper-
ature. Reboot. If prob-
Major
lem persists, return to
factory.
Reboot. If problem per-
Critical
sists, return to factory.
Reboot. If problem per-
Major
sists, return to factory.
TimeProvider 100 User's Guide
set
93