Factory Defaults; General And Communication Parameters - Symmetricom TimeProvider 100 User Manual

Appendix B Specifications and Factory Defaults

Factory Defaults

Factory Defaults
Table B-13. General and Communication Parameters
Description
User Name
User Password
EIA-232 Port
IP Mode
IP Address
Gateway Address
Network Mask
Signal Type (E1)
Alarm Delay
Alarm State
Note: When using the set configuration restore factory
CLI command, the User Name and User Password does return to the
default value in
restore backup CLI command, User Name, User Password, IP
Mode, IP Address, Gateway Address, Network Mask, does not return
to the default value in
104 TimeProvider 100 User's Guide
Default Value
admin 20 ASCII characters
tp100 32 ASCII characters, a minimum of 8
96 bps-8-N-1 Fixed
Static Static | DHCP
192.168.1.15 Valid IPv4 address
192.168.1.1 Valid IPv4 Address
255.255.255.0 Valid IPv4 Mask
2.048 MHz [e1_ccs_no_ssm | e1_ccs4
| e1_ccs4_no_ssm| e1_cas_no_ssm
| e1_cas | e1_cas4_no_ssm | e1_2048m
| e1_ais]
zero seconds 0 –1000 seconds
Enabled Enable | Disable
Table B-13
. When using the set configuration
Table B-13
.
Value Range
098-00106-000 Revision A – March, 2009