Table of Contents
Advertisement
show command log
This command is used to display the entries of the user command history log. All
commands entered by users are logged.
Input:
tp100> show log command <tab>
Response:
start
tp100> show log command
Input:
tp100> show log command ?
Response:
start
end
<enter>
tp100> show log command
Input:
tp100> show log command start 7 end 10
Response:
Line 7, 2008-02-17, 00:02:13, [user: admin]: set clock datetime 2008-10-10,10:10:10
Line 8, 2008-10-10, 10:10:13, [user: admin]: show clock
Line 9, 2008-10-10, 10:10:17, [user: admin]: show gps
Line 10, 2008-10-10, 10:10:29, [user: admin]: show status
tp100>
show output
This command is used to display the configuration of the four output ports for the
E1/T1/2048/1544 signals. The 10 MHz and 1PPS output signals are not
configurable and are not included. The SSM value of the TimeProvider 100 output
depends on the following conditions:
098-00106-000 Revision A – March, 2009
end
-
Start line of the log to display, line 1 to 1000
-
End line of the log to display, line 1 to 1000
-
Execute command
Chapter 5 CLI Commands
Show Commands
TimeProvider 100 User's Guide
67
Advertisement
Table of Contents
