Table of Contents
Advertisement
Chapter 2
Configuration Setup
Log On to TimeProvider 100
Log on is required to configure or view TimeProvider 100 settings. To log on to the
TimeProvider 100, follow these steps:
1. Wait for the system to boot.
2. At the login prompt, type admin, then press Enter.
3. At the password prompt, type tp100, then press Enter.
A successful connection will look like the following example. You will be asked to
type in your user name and password after the system boots up. After typing in the
correct user name admin and password tp100, it will show
command.
Symmetricom TP100
login: admin
Password: *****
tp100>
Note: I
one to two minutes before you try again.
Log On Tips
is the factory shipped user name and
admin
password. The
password. See
information.
Logon sessions can be initiated using the serial port or remotely using Telnet. If
using Telnet, an appropriate TimeProvider 100 network address needs to be
established before remote sessions can be successful.
A serial session will automatically logout whenever 10 minutes elapse without
any user entry. When a session expires, there will be a logon prompt.
A remote (Telnet) session will automatically logout whenever 10 minutes elapse
without any entry. When a session expires, there will be a logon prompt.
The TimeProvider 100 simultaneously supports up to eight log on sessions.
These eight simultaneous log on sessions can be on the serial port, Ethernet
port, or a combination of both ports.
32
TimeProvider 100 User's Guide
f you fail to log in after three tries, the system will wait
command can be used to change the user name and
set user
TimeProvider 100 CLI Command
for you to type in
tp100>
is the factory shipped
tp100
Set, on page 56 for more
098-00106-000 Revision A – March, 2009
Advertisement
Table of Contents
