Table of Contents
Advertisement
Chapter 5 CLI Commands
Show Commands
Response:
event
command
tp100> show log
show event log
This command is used to display the event log and alarm log entries.
Input:
tp100> show log event <tab>
Response:
start
tp100> show log event
Input:
tp100> show log event ?
Response:
start
end
<enter>
tp100> show log event
Input:
tp100> show log event start 7 end 9
Response:
- Line 7, 2008-12-16, 05:59:58, #26, EVENT, SWITCH: switched firmware image to 1
- Line 8, 2008-12-16, 06:03:02, #15, MINOR, ANT_OPEN: GPS antenna open-circuit
- Line 9, 2008-12-16, 06:03:02, #14, MINOR, GPS_CUR: GPS antenna current out of range
tp100>
66
TimeProvider 100 User's Guide
-
Show event log entries, lines 1 to 1000
-
Show command log entries, lines 1 to 1000
end
-
Start line of the log to display, line 1 to 1000
-
End line of the log to display, line 1 to 1000
-
Execute command
098-00106-000 Revision A – March, 2009
Advertisement
Table of Contents
