Signal Type Selection Choices - Symmetricom TimeProvider 100 User Manual

Gps timing and frequency source device

Table of Contents

Chapter 2

Configuration Setup

Set the signal type as desired using the

<selection> SSM-BIT <selection> status <selection>

Table 2-3. Signal Type Selection Choices

Parameter

PORTn

Status

FRAMETYPE

SSM-BIT

For example, set port1 to e1_cas with crc and ssm bit set to 5, type and enter the

following command:

tp100> set output port1 frametype e1_cas4

tp100> set output port1 ssm-bit 5

The output LED provides high-level indication about output status as shown in

Reading LED

Caution: After making configuration changes, you must use the set

configuration save CLI command to save the latest

configuration. See

information.

TimeProvider 100 User's Guide

choices are shown in

Port1, Port2, Port3, Port4

Enable, Disable

e1_css_no_ssm, e1_ccs4, e1_ccs4_no_ssm, e1_cas_no_ssm,

e1_cas4, e1_cas4_no_ssm, e1_2048m, e1_ais

4, 5, 6, 7, 8

Conditions, on page 88.

set configuration

set output PORTn frametype

Table

2-3.

Selection

, on page 72 for more

098-00106-000 Revision A – March, 2009

command. The

Table of Contents