Table of Contents
Advertisement
Check GPS Status
After logging in to the system, the
GPS status. The command response is shown in the following example. The
"Number of tracked satellite" information can we used to judge whether the GPS
cable is connected correctly. When the
than zero, the GPS connection is working properly.
tp100> show GPS
GPS information
GPS Position Mode
GPS Mask
GPS Antenna Delay
GPS System Time
Number of tracked satellite
GPS Latitude
GPS Longitude
GPS Height
Check Inventory Information
The
show inventory
TimeProvider 100 as shown in the following example:
tp100> show inventory
---------------------------------------------------------------------------
|Part number
|Serial
|---------------|---------|---------|---------|---------|-----------------|
|090-95000-01
| R03009
---------------------------------------------------------------------------
Configure the TimeProvider 100 IP Address
This step establishes the IP settings of the TimeProvider 100. The LAN connection
labeled MGMT & NTP can be used for configuration of the TimeProvider 100.
The following two examples show how to configure Ethernet ports.
098-00106-000 Revision A – March, 2009
show gps
Number of tracked satellite
command is used to check the inventory information in the
|HW Ver
|SW Ver
| 2
|0.0.14
Chapter 2 Installation and Configuration
command can be used to check the
- Auto
- 5
- 0.00E+00
- week:1809, second:200730
- 8
- N39:54:12.726
- E116:26:45.318
- 134.90
|FPGA
|Manufacture date |
|0x17
|11/14/2008
TimeProvider 100 User's Guide
Configuration Setup
is larger
|
33
Advertisement
Table of Contents
