Set Gps - Symmetricom TimeProvider 100 User Manual

Chapter 5 CLI Commands
Set Commands
Note: (1) "Restore Factory" is the full restoration of factory
configuration, including default IP configuration and default user date.
(2) "Restore Backup" restores all configuration parameters set by the
user from the backup FLASH, except IP configuration and user data
(user IDs and passwords). (3) The manual RESET button restores
only the factory IP port configuration and default user data (user ID
and password). The manual RESET button is located on the back of
the TimeProvider 100 unit. Press the button down and hold it for three
seconds to perform the RESET.
Input:
tp100> set configuration save
Response:
Configuration has been saved
tp100>

set gps

This command is used to configure GPS engine parameters (antenna cable length,
antenna angle mask, and whether search is automatic or manually seeded.)
Input:
tp100> set gps <tab>
Response:
cable-delay
Input:
tp100> set gps mode?
Response:
auto
manual
Input:
tp100> set gps cable-delay ?
Response:
<cabledelay String 1 - 16> - Enter cable delay, 0 to 0.0009 second
74 TimeProvider 100 User's Guide
mask mode
- Automatic mode
- Manual mode
098-00106-000 Revision A – March, 2009