Table of Contents
Advertisement
Chapter 2
Installation
Figure 2-1.
Location of TimeProvider 100 Product Label
Rack Mounting the TimeProvider 100
The installation procedure described in this section provides general guidelines for
installing the TimeProvider 100. Refer to
page 41 for information about available rack mount kits and mounting adapter
bracket kits.
When installing the TimeProvider 100, always follow applicable local electrical
standards. Use the following steps to mount the TimeProvider 100 in a rack.
1. Attach the rack mounting brackets to the TimeProvider 100 using 6-32 x 1/4-inch
screws.
Note: Using screws other than 6-32 x 1/4 inch could cause damage
to the unit. Always use the proper screws for the equipment rack.
2. Ensure that the mounting brackets on both sides are attached at equal distances
from the front of the unit.
3. Mount the TimeProvider 100 to the front of the equipment rack rails with four
screws and associated hardware.
28
TimeProvider 100 User's Guide
Part Numbers and Return
098-00106-000 Revision A – March, 2009
Information, on
Advertisement
Table of Contents
