Table of Contents
Advertisement
Installation and Configuration Checklist
To make sure that you have properly installed and configured your TimeProvider
100, use
Table 2-4
further details about each of the operations, refer to the section shown
Table 2-4. Installation and Configuring Checklist
Operation
TimeProvider 100 Site Survey
Unpack Unit
Shelf Mounting (optional)
Shelf Grounding (optional)
Apply Power
Establish Serial Communication
Log On to TimeProvider 100
Check GPS Status
Check Inventory Information
Configure TimeProvider 100 IP Address
Confirm TimeProvider 100 Network
Communication
Configure Outputs
Now that you have completed the required steps to install and configure the
TimeProvider 100 for operation, the Command Line Interface (CLI) can be used for
additional configuration or status monitoring. Refer to
Command
Set, on page 56 for further details.
098-00106-000 Revision A – March, 2009
to verify that you have completed the required operations. For
More Information
Site Survey
Unpack the Unit
Rack Mounting the TimeProvider
100
, on page 28
Ground the Shelf
Apply Power
Establish Serial Communication
page 31
Log On to TimeProvider 100
page 32
Check GPS Status
Check Inventory Information
page 33
Configure the TimeProvider 100 IP
Address
, on page 33
Confirm TimeProvider 100 Network
Communication
Configure Frequency Outputs
page 37
Chapter 2 Installation and Configuration
Installation and Configuration Checklist
, on page 25
, on page 27
, on page 29
, on page 30
, on
, on
, on page 33
, on
, on page 36
, on
TimeProvider 100 CLI
TimeProvider 100 User's Guide
inTable
2-4.
Complete
39
Advertisement
Table of Contents
