Table of Contents
Advertisement
Response:
tp100>
Note: When an Ethernet port is in static mode, set ipconfig
mgmt restart will activate a newly entered IP address. When the
Ethernet port is in the DHCP mode, set ipconfig mgmt restart
will try to acquire an IP address within 60 seconds. Use ipstatus to
confirm the port configuration after using the set ipconfig mgmt
restart command.
set output
This command is used to configure the four telecom output ports. Parameters are
frame type, SSM bit position, and whether the port is enabled.
Input:
tp100> set output <tab>
Response:
port1
tp100> set output
Input:
tp100> set output ?
Response:
port1
port2
port3
port4
tp100> set output
Input:
tp100> set output port2 <tab>
Response:
frametype
tp100> set output port2
098-00106-000 Revision A – March, 2009
port2
port3
port4
- Output port 1
- Output port 2
- Output port 3
- Output port 4
ssm-bit
state
Chapter 5 CLI Commands
Set Commands
TimeProvider 100 User's Guide
79
Advertisement
Table of Contents
