Show Commands; Show Active_Alarm - Symmetricom TimeProvider 100 User Manual

Show Commands

This is a group of commands that are used to display various system parameters.
Input:
tp100> show <tab>
Response:
active_alarm
alarmconf
clock
Input:
tp100> show ?
Response:
snmp
eia232
users
alarmconf
active_alarm
ipconfig
gps
clock
log
output
inventory
status
ipstatus
image
tp100> show

show active_alarm

This command is used to display a list of all active alarms in the system. These are
alarms that were activated and not yet cleared.
Input:
tp100> show active_alarm
Response (Example):
2008-11-18, 01:43:06, #16, MAJOR, ANT_OPEN
098-00106-000 Revision A – March, 2009
eia232 inventory
gps ipconfig
image ipstatus
-Display SNMP configuration
- Display EIA-232 port parameters
-Display user list
-Display alarm configurations
-Display active alarms
-Display IP ports configuration
-Display GPS information
-Display UTC date and time
-Display entries of selected log
-Display output configuration
-Display manufacturing information
-Display system status information
-Display IP ports status
-Display firmware image information
Chapter 5 CLI Commands
Show Commands
log status
output users
snmp
TimeProvider 100 User's Guide 61