Table 5-3 Entering The Country Code And Selecting The Password Type - Siemens HiPath 5000 Service Manual

start_h3.fm
Starting Up HiPath 3000
Starting Up HiPath 3800
Table 5-3 Entering the Country Code and Selecting the Password Type
Step
Notes:
On step 4 and step 5: If a new password is issued, both steps are omitted when calling
●
the system again.
On step 6: No country adjustment is necessary for Germany because the system starts
●
up with German codes.
On step 7: When selecting the fixed password, the default password (31994) overwrites
●
the new password entered under step 4.
Entering the country code starts the system. Any data that has already been stored, such as
system speed-dialing destinations and classes of service, is deleted or reset to the default val-
ue.
For Brazil only: CO call privileges, ringback protection per trunk
7
If the system was initialized with the country code for Brazil, the option for saving the
digits dialed and transmitting them via the system (dial rule 1A) is not activated.
This can lead to dialing problems at DTMF terminals because the system waits for
the dial tone from the analog trunk and does not set up the connection between the
DTMF terminal and the trunk until it recognizes the dial tone. Digits dialed before dial
tone recognition are therefore not recognized by the CO. This in turn can impact CO
call privileges.
To avoid this, Least Cost Routing LCR should be activated for all systems with the
country code for Brazil and with connection to analog trunks with DTMF signaling.
After you enter a country code, the default data is only guaranteed to load correctly
>
if the system software has been officially released for that country.
5-8
Entry Description
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
P31003-H3560-S403-54-7620, 09/05