Table 6-9 P 500 Ups - Meaning Of Displays, Switches And Jacks - Siemens HiPath 5000 Service Manual

P 500 UPS - Meaning of Displays, Switches and Jacks
Table 6-9 P 500 UPS - Meaning of Displays, Switches and Jacks
No.
1 LED displays the status of the P 500 UPS.
green = input voltage (line voltage) is functioning
●
red = UPS is suppling voltage or fault has been detected
●
2 Display shows UPS operating status
NORMAL
●
CHARG'G
●
BATTERY
●
and reports the charging status of the battery (25, 50, 75 or 100%).
3 On/off switch
4 Input (jack for input voltage (line voltage))
There is a cavity under the jack for the input fuse (with spare fuse enclosed).
5 3-pin DIP-FIX switch:
1: reduces the response voltage (minimum line voltage value before UPS activation)
●
– 10 V with 220/240-V systems
– 5 V with 110/120-V systems.
2: increases the response voltage by 5%
●
3: reduces the response voltage by 5%
●
Switch positions normally: DIP FIX 1 = off, DIP FIX 2 and 3 = on
6 Reset key
deactivates the acoustic alarm if the input voltage fails, that is, when using the UPS.
●
This alarm cannot be deactivated if the battery voltage falls under a certain value.
activates the UPS cold start.
●
To protect the battery from deep discharging, the UPS can only be activated when
the line voltage is connected. By activating the "on" switch (1) and then pressing the
reset key, the P 500 UPS can also be activated without a network connection (cold
start).
The connected server must be disconnected before a cold start.
The P 500 UPS needs between 5 and 20 s to reach the set output voltage. To avoid
malfunctions the connected server should not be connected immediately.
7 9-pin jack for connection to the communication server
Special monitoring software can shut down the specified server via this jack, for exam-
ple, in the case of extended power failures.
8 Jacks for power supply to the communication server to be monitored.
P31003-H3560-S403-54-7620, 09/05
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
HiPath 5000 Startup and Administration
Connecting an Uninterruptible Power Supply to HiPath 5000
Description
NOT USED IN HiPath 3000/5000.
start_h5.fm
6-63