Optipoint Acoustic Adapter - Siemens HiPath 5000 Service Manual

wclient.fm
Workpoint Clients
optiPoint 500
10.2.3.4

optiPoint Acoustic Adapter

The optiPoint acoustic adapter is used for connecting
a headset (121 TR 9-5) (see Section 10.7.2)
●
an active loudspeaker box and a desk microphone via the Y cable
●
busy display/door opener and secondary bell/light paging, etc. (each with its own power
●
supply) via floating contacts (not supported when using the adapter on optiPoint 410 and
optiPoint 420).
1 2
Figure 10-15 optiPoint Acoustic Adapter
Notes on the optiPoint acoustic adapter
Section 10.2.4 contains details on a possible additional external power supply.
●
The internal components of the optiPoint terminal are deactivated in speakerphone mode
●
if an external microphone and an external loudspeaker are used (sense lead).
optiPoint 500 basic does not support the connection of an external microphone to the op-
●
tiPoint acoustic adapter.
The speakerphone mode selection is independent of whether the internal or an external
●
speakerphone is used. External speakerphones have precedence over internal speaker-
phones with the exception of manual intercom and signaling procedures.
The internal microphone, the transmitter inset and any microphone connected to the opti-
●
Point acoustic adapter are muted in the "Mute" audio state.
10-26
Assignment of the three connection jacks:
1 Connecting a headset with the following electrical
values (121 TR 9-5):
●
●
3
2 Connecting a loudspeaker and microphone using Y
cable (see Figure 10-16)
3 Floating contacts (see Table 10-2), load capacity of
max. 5 W at 24 Vac or 60 Vdc
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
Microphone (electret interface):
– max. power: 400 µA,
– supply voltage: 5 V ± 10%
– series resistor: 5 kΩ ± 10%
Acoustic transformer:
Impedance: 150 Ω ± 10%
–
– EBD: 13 dB ± 2.5 dB
P31003-H3560-S403-54-7620, 09/05