Setting Up A Stacked Three-Cabinet System - Siemens HiPath 5000 Service Manual

Hide thumbs Also See for HiPath 5000:

Table of Contents

Installing HiPath 3000

Installing HiPath 3750, HiPath 3700

Setting Up a Stacked Three-Cabinet System

Up to two cabinets can be stacked.

Remove the front and rear

(EC2). Place EC2 next to the BC in the installation site and make sure that it is

level and stable. Correct any differences in height.

Place expansion cabinet (EC1) on basic cabinet. Insert the feet on EC1 into the

depressions on the top of the BC.

Attach the three cabinets using four connecting plates, each held by two screws

with washers (Figure 4-57).

Make sure that the connecting plates are mounted in the correct direction (inside

the cabinets and pointing inward).

The connecting plates must be installed to ensure proper grounding for free-stand-

ing systems.

For U.S. only: You can install seismic anchors for greater stability, as is required in

some installations. Additional information can be found in Section 4.3.3.4.9.

Take note that the bolts and inserts included in the seismic anchor kit are designed

for concrete floors. Bolts for other surfaces must be requested or supplied separate-

stabilizer foot

on the basic cabinet and one on the expansion cabinet

HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual

P31003-H3560-S403-54-7620, 09/05

Table of Contents

Hipath 3000 Hipath 3800