Figure 3-91 Pin Assignments In Mw Jacks - Siemens HiPath 5000 Service Manual

boards.fm
Boards for HiPath 3000
Peripheral Boards
Connecting ISDN telephones
Depending on the system, you can set up a maximum of four internal S
A maximum of eight ISDN terminals can be addressed on each S
The system does not assign the MSN until the S
can be read out via administration.
When you set up an S
the system. The S
0
zure.
If no MSN is entered in the terminal, a default MSN is automatically assigned after
>
you change the S
Configuring an S
0
S telephones cannot be directly connected to an STLSX board's Mini-Western jack via the ca-
0
ble supplied. You must first install a jack with cross-connected cables (see Figure 3-86).
Assignment of MW jack pins 1- 8:
8-pin
8 7 6 5
SR SX SX SR
4-pin
4 3
SR SX SX SR
Figure 3-91 Pin Assignments in MW Jacks
3-226
bus, it is assigned an MSN. This MSN is the first free station number in
0
station is immediately available under this MSN, without an outgoing sei-
port to "Euro bus" in system administration.
0
bus with a Mini-Western jack
4 3 2 1
2 1
port is configured on the "Euro bus"; the MSN
0
6-pin
6 5
SR
Always establish contact on the
center four pins.
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
buses (S
0
bus.
0
4 3 2 1
SX SX SR
P31003-H3560-S403-54-7620, 09/05
1 to S 4).
0 0