Siemens HiPath 5000 Service Manual page 1131

optiPoint 400, optiPoint 410, optiPoint 410 S, optiPoint 420, optiPoint 420 S, optiPoint 600 office
C.7 optiPoint 400, optiPoint 410, optiPoint 410 S, optiPoint 420,
optiPoint 420 S, optiPoint 600 office
The workpoint clients support the flexible configuration (Flexible Port Numbering) of each TCP
and UDP port number, with the exception of:
SNMP
●
SNTP
●
DNS
●
WAP Push
●
WAP Push secure
●
The following table shows the configurable port numbers and their output parameters. The Port
Base Number is used in some cases. The Port Base Number is the configurable port number,
not the port numbers derived from the Port Base Number.
Note: The workpoint client may have to be restarted after a port number has been changed.
Table C-7 optiPoint 400, optiPoint 410, optiPoint 410 S, optiPoint 420, optiPoint 420 S,
optiPoint 600 office - Used IP Protocols and Port Numbers
Function
H.225.0 RAS Port Area
H.225.0 Call Signaling Port Area
H.245 TCP Channel Port Area (Lo-
cal)
H.245 TCP Channel Port Area (Re-
mote)
RTP Port Area (Local)
RTP Port Area (Remote)
RTCP Port Area (Local)
RTCP Port Area (Remote)
HTTP Hypertext Transport Protocol
P31003-H3560-S403-54-7620, 09/05
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
IP Protocols and Port Numbers Used with HiPath 3000/5000 V6.0
Default port
UDP
1719
5010,
5012,
5014,
5016
Any
5011,
5013,
5015,
5017
Any
TCP
1720
>1024
Any
The RTP port number is even-num-
bered. The RTCP port number is equiv-
alent to the RTP port number + 1.
5004 to 5007 are reserved by IANA.
The RTP port number is even-num-
bered. The RTCP port number is equiv-
alent to the RTP port number + 1.
5004 to 5007 are reserved by IANA.
8085
portnos.fm
Note
C-13