Tmgl4 (For U.s. Only); Figure 3-123 Tmgl4 (For U.s. Only) - Interfaces (S30810-Q2918-X) - Siemens HiPath 5000 Service Manual

3.3.36

TMGL4 (for U.S. only)

Introduction
A TMGL4 trunk module connects up to four analog ground-start or loop-start trunks to HiPath
3550 and HiPath 3350.
Ground start is the default.
Warning
7
You must disconnect the power and remove the slip-on connectors from the TMGL4
board before removing it from the system.
Do not connect the slip-on connectors to the TMGL4 board until the board is seated
in its slot and the system power is on.
Failure to follow these instructions may severely damage the system.
Interfaces
To trunks
To ANI4
Figure 3-123 TMGL4 (For U.S. Only) - Interfaces (S30810-Q2918-X)
P31003-H3560-S403-54-7620, 09/05
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
1
TMGL4 board
X2
8
X3
Boards for HiPath 3000
Peripheral Boards
50
To
CUP/
X1
CUC
2
boards.fm
3-307