Example Of Configuring A Single-Channel Call - Lucent Technologies MAX 6000 Configuration Manual

Example of configuring a single-channel call

Host/AIM6
Port3 Menu
Configuring a dual-port call
In a dual-port call, two inverse multiplexing ports on the MAX unit connect the call to the
serial host. The two ports are a primary port and a secondary port. However, the unit places the
two calls in tandem and clears the calls in tandem, and considers them a single call. The
following restrictions apply to dual-port connections:
•
•
•
•
In the following example, the Host interface profile must enable port pairing for dual-port
calls. (For details, see "Enabling dual-port calls" on page 3-51.) In addition, a T1 or E1 line has
two of its channels configured with the telephone number 1212 (a hunt group). To route the
call answered on the 1212 hunt group to the paired ports for a dual-port call:
1
2
3
To configure the dual-port call:
1
2
MAX 6000/3000 Network Configuration Guide
Directory
terminal-adaptors
Name=terminal-adaptors
Dial #=241
Call Type=1 Chnl
The selected data service must be available end-to-end.
The dialing method cannot be V.25 bis.
The answer number must be the same for both ports.
If trunk groups are in use, both channels of the call must be in the same trunk group.
Open Host/Dual > Port1 Menu > Port Config.
This is the Port profile for the primary port (Port 1).
Set the Ans 1# parameter to specify the hunt-group answer number.
Host/Dual
Port1 Menu
Port Config
Port Name=Port1
Ans 1#=1212
Note: Do not set the Ans # parameter for the secondary host port (Port 2).
Exit the profile and, at the exit prompt, select the exit and accept option.
Open a call profile in the Host/Dual > Port1 Menu > Directory menu.
This is the call profile for the primary port (Port 1).
Set the Dial # parameter to specify the dial number of the remote codec. For example:
Host/Dual
Port1 Menu
Directory
hunt-groups
Name=hunt-groups
Dial #=6-201-555-7878
If the dual-port call requires two dial numbers, specify both numbers. Separate them with
an exclamation mark. For example:
Configuring WAN Access
Configuring Host/AIM6 and Host/Dual ports
3-57