Bn Slot And Bn Prt/Grp Parameters - Lucent Technologies MAX 6000 Configuration Manual

Each line has two B channels for user data. To configure the B channels, open BRI/LT > Line
Config > Line Config profile > Line N and set the following parameters.
Parameter
B1 Usage
B2 Usage
B1 Slot
B2 Slot
B1 Prt/Grp
B2 Prt/Grp
B1 Trnk Grp
B2 Trnk Grp
For detailed information about each parameter, see the MAX Reference.
B N Slot and B N Prt/Grp parameters
With the BN Slot and BN Prt/Grp parameters, you can assign a channel to a slot or slot/port
combination for a digital modem, AIM port, or the Ethernet port. The slot/port combination
configuration affects both inbound call routing and outbound calls. In effect, it reserves the
channel for calls to and from the specified slot or port. For details, see "Configuring call
routing" on page 3-58.
Note: You cannot control whether an incoming call rings on the first or second B channel, so
set the BN Slot parameters to identical values.
With a nailed channel, BN Prt/Grp is a Group number. To make use of this nailed connection,
the Group number is referenced in a Connections or call profile.
MAX 6000/3000 Network Configuration Guide
Specifies
Usage (Switched, Nailed, or Unused) of the first B channel. To support
IDSL, you must set this parameter to Nailed.
Usage (Switched, Nailed, or Unused) of the second B channel. To support
IDSL, you must set this parameter to Nailed.
Slot number for routing calls to the first B channel. Should have the same
setting as B2 Slot.
Slot number for routing calls to the second B channel. Should have the
same setting as B1 Slot.
For switched channels, a port number to be used with the B1 Slot
parameter for call routing purposes. For nailed channels, a group number,
which will be referenced from a call or Connection profile, assigning the
channels for a connection.
For switched channels, a port number to be used with the B 2 Slot
parameter for call routing purposes. For nailed channels, a group number,
which will be referenced from a call or Connection profile, assigning the
channels for a connection.
Trunk group to which to assign the first B channel. Makes the channel
available for outbound calls.
Trunk group to which to assign the second B channel. Makes the channel
available for outbound calls.
Configuring WAN Access
Configuring IDSL connections
3-43