Configuring Dial-In Ppp For Appletalk - Lucent Technologies MAX 6000 Configuration Manual

For detailed information about each attribute, see the TAOS RADIUS Guide and Reference.

Configuring dial-in PPP for AppleTalk

You can configure a MAX unit so that individual users can dial into an AppleTalk network by
using a PPP dialer, such as AppleTalk Remote Access 3.0 or Pacer PPP. The MAX unit does
not need to be set up as an AppleTalk router to support dial-in PPP to AppleTalk.
You can set up a unit to enable an AppleTalk client to dial in using PPP in two ways:
•
•
Configuring an AppleTalk PPP connection with a Connection profile
To use a Connection profile to configure an AppleTalk PPP connection:
1
2
3
4
5
6
7
8
Configuring an AppleTalk PPP connection with a Names/Passwords
profile
To use a Names/Passwords profile to configure an AppleTalk PPP connection:
1
2
3
4
MAX 6000/3000 Network Configuration Guide
With a Connection profile
With a Names/Passwords profile
Open the Ethernet > Mod Config subprofile.
Set the Appletalk parameter to Yes.
Open the appropriate Connection profile.
Set the Route Appletalk parameter to Yes.
Open the AppleTalk Options profile.
90-103 apple
AppleTalk Options
Peer=Dialin
Zone Name=N/A
Net Start=N/A
Net End=N/A
Set the Peer parameter to indicate whether the connection for this profile is a single-user
PPP connection or a router.
Peer=Dialin specifies that the profile is for a single-user PPP connection. All other
parameters in the AppleTalk Options menu are N/A. Peer=Router specifies that the profile
is for a connection with a router (such as a Pipeline unit).
If you selected Peer=Dialin, you have completed the configuration. Close the AppleTalk
Options menu and save your changes. If you selected Peer=Router, you need to configure
the other parameters in the AppleTalk Options menu.
Exit the profile and, at the exit prompt, select the exit and accept option.
Open the Ethernet> Mod Config profile.
Set the Appletalk parameter to Yes.
In the Answer profile, open the PPP Options subprofile.
Set the Route Appletalk parameter to Yes.
Configuring Individual WAN Connections
Configuring dial-in PPP for AppleTalk
4-73