Table of Contents
Advertisement
3
4
5
6
7
8
If the profiles you have configured are not the active Sys Config profiles and the active Line
Config profile, activate them as described in "Activating a profile" on page 2-7.
Example of configuring outbound calls
In this sample configuration, the terminating equipment on line 1 can make an outbound call
using trunk group 5 and Dial Plan profile 2. With this configuration, the caller at the Host/BRI
terminating equipment dials 502-408-555-1212 and connects to the device whose telephone
number is 408-555-1212 (trunk group 5, dial plan 2):
System
Sys Config
System
Dial Plan
Host/BRI
Line Config
Configuring local BRI-to-BRI calls
To enable trunk groups:
1
2
3
MAX 6000/3000 Network Configuration Guide
Open a Net/T1 (or Net/E1) profile and make sure that some of the line's channels are
assigned to the same trunk group. Then, exit the profile and, at the exit prompt, select the
exit and accept option.
Open a System > Dial Plan profile.
Set the Data Service and PRI # Type parameters to Inherit.
Open a Host/BRI > Line Config > Line Config profile > Line N subprofile.
Set the Dial Plan parameter to Extended.
Exit the profile and, at the exit prompt, select the exit and accept option.
Use Trunk Grps=Yes
Boston
Name=Boston
Call-by-Call=6
Data Svc=Inherit
PRI # Type=Inherit
local
Name=local
Line 1...
Enabled=Yes
Dial Plan=Extended
Ans 1#=1212
Ans 2#=
Open System > Sys Config and set Use Trunk Grps to Yes to enable trunk groups
systemwide.
Exit the profile and, at the exit prompt, select the exit and accept option.
Open the Host/BRI > Line Config > Line Config profile > Line N subprofile for the line
you are configuring, and set the Dial Plan parameter to Trunk Grp to specify the use of
trunk groups.
Configuring WAN Access
Configuring Host/BRI lines
3-41
Advertisement
Chapters
Table of Contents
