Parameters And Commands - Lucent Technologies MAX 6000 Configuration Manual

Parameters and commands

Five parameters and three commands enable you to configure the MAX X.25 PAD to meet the
expectations of devices to which it might connect.
The five parameters appear in the Ethernet > Connections > Connection profile > Encaps
Options submenu for an X.25/PAD connection. (Note that you must set Encaps to X.25/PAD in
the Connection profile to access the X.25/PAD parameters in Encaps Options.) The parameters
as described on page 6-12 are:
•
•
•
•
•
One terminal server command:
•
Two X.25 PAD commands:
•
•
X28 terminal–server command
X28 which appears in the list of terminal-server commands, accesses the PAD. It is not case
sensitive. To access the PAD, enter the X28 command at the terminal-server prompt:
% X28
Alternatively, you can enter the PAD command, which is identical to the X.28 command.
X.25 PAD commands
The two X.25 PAD commands are Storeprof and Call.
Storeprofile
Use the Storeprof command to store the current settings of the PAD parameters in a specified
X.3 profile.
Note: At the moment, you can store the current settings only in the X.3 profile named
Custom.
To store the current settings of the PAD parameters in the X.3 profile named Custom, use the
following syntax to enter the Storeprof command at the PAD prompt:
storeprof custom
For instructions on how to set the X.3 parameters, see "X.25 PAD commands" on page 6-18.
MAX 6000/3000 Network Configuration Guide
PAD banner msg
PAD prompt
NUI prompt
NUI PW prompt
PAD Alias #n (where n=1–3)
X28
Storepro
Call
Configuring X.25
Customizing script support for X.25 PAD
6-25