Configuring A Port Config Profile - Lucent Technologies MAX 6000 Configuration Manual

Parameter
Max DS0 Mins
Max Call Mins
Port Password
For detailed information about each parameter, see the MAX Reference.

Configuring a Port Config profile

To configure a port for RS-366 dialing:
1
2
3
4
5
Example of a Port Config profile
Host/AIM6
Port1 Menu
MAX 6000/3000 Network Configuration Guide
Specifies
Maximum number of DS0 minutes a call can be online. Applies to
calls from the AIM port within the specified time period. When the
usage exceeds the specified maximum, the MAX cannot place any
more calls, and it takes any existing calls offline.
Maximum number of minutes a call can be online at the port,
regardless of bandwidth, before the MAX disconnects it. This
maximum limits the usage of switched channels, even if the MAX
combines these channels with nailed ones. Although the MAX
disconnects the switched channels when a call exceeds the value of
this parameter, the nailed channels remain connected.
Password for incoming AIM or BONDING calls. Authentication is
used only if the calling unit has a password defined in the Call profile.
Open a Host/AIM6 > Port1 Menu > Port Config profile and set the Port Name parameter
to assign a name to the profile.
Set the Ans N# parameters to configure call routing.
Set the Dial, Answer, and Clear parameters appropriately for the codec.
Set the Dial Plan parameter to trunk group to specify that the digits following the first digit
constitute an ordinary phone number, or set it to Extended to specify that the MAX uses
the extended dial plan.
Exit the profile and, at the exit prompt, select the exit and accept option.
Directory
Port1
Port Name=Port1
Dial Plan=Trunk Grp
Ans 1#=1212
Ans 2#=1213
Ans 3#=1214
Ans 4#=1215
Dial=RS-366 ext1
Answer=Auto
Clear=Terminal
Configuring WAN Access
Configuring Host/AIM6 and Host/Dual ports
3-49