Configuring A Connection With Local Servers Only - Lucent Technologies MAX 6000 Configuration Manual

Configuring IPX Routing
Configuring IPX routing connections
6
7
8
9

Configuring a connection with local servers only

In this example, the MAX unit connects to a local IPX network that supports both servers and
clients, and connects to a geographically remote network that supports one or more NetWare
clients. Figure 11-3 shows the setup.
11-16
Encaps options...
Send Auth=CHAP
Recv PW=*SECURE*
Send PW=*SECURE*
IPX options...
IPX RIP=None
IPX SAP=Both
NetWare t/o=30
SAP HS Proxy=N/A
SAP HS Proxy Net#1=N/A
SAP HS Proxy Net#2=N/A
SAP HS Proxy Net#3=N/A
SAP HS Proxy Net#4=N/A
SAP HS Proxy Net#5=N/A
SAP HS Proxy Net#6=N/A
Exit the profile and, at the exit prompt, select the exit and accept option.
Open an IPX Route profile.
Set IPX RIP to None in the Connection profile, and configure a static route to the remote
server.
Set up a route to the remote NetWare server (SERVER-1). Use the following settings:
Ethernet
IPX Routes
SERVER-1
Server Name=SERVER-1
Active=Yes
Network=CFC12345
Node=000000000001
Socket=0451
Server Type=0004
Connection #=2
Note: The Connection # parameter in the IPX Route profile must match the number of
the Connection profile you configured for that site. If you specify the internal network
number of a server, make sure you specify values for Server Name and Server Type. If you
specify an external network, do not specify a value for Server Name or Server Type.
Exit the profile and, at the exit prompt, select the exit and accept option.
MAX 6000/3000 Network Configuration Guide