Figure 11-1 A Dial-In Netware Client - Lucent Technologies MAX 6000 Configuration Manual

Configuring IPX Routing
Configuring IPX routing connections
Figure 11-1. A dial-in NetWare client
To configure an IPX routing connection for the client:
1
2
3
4
5
6
7
8
9
10 Open the IPX Options subprofile and specify a dial-in client:
11 Exit the profile and, at the exit prompt, select the exit and accept option.
11-12
MAX
Open Ethernet > Mod Config > Ether Options and verify that an IPX pool assignment
exists. For example:
Ethernet
Mod Config
Ether options...
IPX Pool #=CCCC1234
Exit the profile and, at the exit prompt, select the exit and accept option.
Open Answer > PPP Options.
Enable IPX routing and PAP/CHAP authentication:
Ethernet
Answer
PPP options...
Route IPX=Yes
Recv Auth=Either
Exit the profile and, at the exit prompt, select the exit and accept option.
Open the Connection profile you will use to configure the dial-in user's connection.
Set the Station parameter to specify the dial-in client's login name, and activate the profile
by setting Active to Yes. For example:
Ethernet
Connection
Connection profile
Station=scottpc
Active=Yes
Enable IPX routing:
Route IPX=Yes
Select PPP encapsulation and configure the dial-in client's password. For example:
Encaps=PPP
Encaps options...
Recv PW=scottpw
IPX options...
Peer=Dialin
IPX RIP=None
WAN
Modem
MAX 6000/3000 Network Configuration Guide