Figure 4-9 Bidirectional Chap For All Incoming Calls To The Max Unit - Lucent Technologies MAX 6000 Configuration Manual

Figure 4-9. Bidirectional CHAP for all incoming calls to the MAX unit
To configure bidirectional CHAP on the MAX unit for all incoming calls, proceed as follows:
1
2
3
4
5
6
7
8
Note: When you set the Recv-Auth parameter to Any, the MAX unit can accept both PAP and
CHAP authentication. The Bi-Dir Auth setting will be used only if a form of CHAP
authentication has been negotiated during LCP negotiation. If any form of PAP authentication
has been negotiated, and Bi-Dir Auth is set to Required, the authentication takes place in only
one direction. The calling unit authenticates the MAX unit.
Setting up bidirectional CHAP on the MAX unit for selected incoming calls
Figure 4-10 shows a configuration in which the MAX unit authenticates the calling device by
means of CLID or DNIS authentication. The MAX unit and the dial-in client then authenticate
each other by means of CHAP.
MAX 6000/3000 Network Configuration Guide
MAX unit
Open the Ethernet > Answer > PPP Options submenu.
Set the Receive Auth parameter to Either, CHAP, or MS-CHAP.
Set the Bi-Dir Auth parameter to Required or Allowed. Required specifies that
bidirectional authentication must be carried out or the call is dropped. Allowed specifies
that authentication can be bidirectional. The MAX unit identifies the calling device, and
the calling device can identify the MAX unit, but the calling device need not do so for the
call to be accepted.
Exit the profile and, at the exit prompt, select the exit and accept option.
For each incoming call, open a Ethernet > Connections > Connection profile > Encaps
Options subprofile.
Set the Send PW parameter to any text string. The password you specify is the one sent to
the calling unit during the authentication initiated by the calling unit.
Set the Recv PW parameter to any text string. The password you specify is the one sent by
the calling unit during the authentication initiated by the MAX unit.
Exit the profile and, at the exit prompt, select the exit and accept option.
Configuring Individual WAN Connections
Configuring bidirectional CHAP support
Recv PW sent
Pipeline unit
WAN
Send PW sent
Dial-in clients
4-65