Configuring A Single-Channel Call - Lucent Technologies MAX 6000 Configuration Manual

Configuring WAN Access
Configuring Host/AIM6 and Host/Dual ports
7
8
9
Example of a FT1-B&O call
Host/AIM6
Port N Menu
Host/AIM6
Port1 Menu
Host/AIM6
Port2 Menu

Configuring a single-channel call

The following procedure provides a connection between two terminal adaptors connected to
two AIM ports on the MAX unit. A call between AIM ports on the same unit remains entirely
local. The MAX does not use any WAN channels. To configure a single-channel port-to-port
call:
1
2
3
4
3-56
Open the Port Config profile, which in this case is Host/AIM6 > Port1 Menu > Port
Config.
Set the Idle and Dial parameters to specify how the switched channels connect.
These settings must be the same in the device at each end of the link. The settings shown
beginning with step 1 above connect the switched channels when the host equipment at
both ends sets DTR active. As an alternative, the settings for the second Host/AIM6
profile in the "Example of a FT1-B&O call" connect the channels at power-up.
Exit the profile and, at the exit prompt, select the exit and accept option.
Directory
ft1-bc
Name=ft1-bo
Call Type=FT1-B&O
Call Mgm=Dynamic
Group=3
FT1 Caller=Yes
Port Config
Idle=None
Dial=DTR
Port Config
Idle=Call
Dial=Terminal
Open a call profile in the Host/AIM6 (Host/Dual) > Port3 Menu > Directory menu.
Set the Dial # parameter to specify a value in a special three-digit format.
(For more information, see "Routing outbound calls" on page 3-68.)
Set the Call Type parameter to specify a single-channel call type.
Exit the profile and, at the exit prompt, select the exit and accept option.
MAX 6000/3000 Network Configuration Guide