Configuring Carrier-Specific Services - Lucent Technologies MAX 6000 Configuration Manual

Configuring WAN Access
Configuring T1 lines
Input Sample
Count
For detailed information about each parameter, see the MAX Reference.

Configuring carrier-specific services

To enable the MAX to communicate with your carrier's switch, and vice versa, obtain values
for the Call-by-Call, T1-PRI:PRI # Type, and T1-PRI:NumPlanID parameters from your
service provider. The value specified for the Call-by-Call parameter sets the signaling value for
routing calls. The T1-PRI:PRI # Type and T1-PRI:NumPlanID parameters specify values that
the MAX unit applies to outbound calls on PRI lines so that the switch can properly interpret
the telephone number dialed.
To configure carrier-specific services, open the Net/T1 > Line Config profile > Line N
subprofile for the line you are configuring and set the following parameters:
Parameter
Call-by-Call
T1-PRI:PRI # Type
T1-PRI:NumPlanID NumberPlanID field in the called party's information element.
For detailed information about each parameter, see the MAX Reference.
Using MAXDAX
MAXDAX enables you to route incoming calls from T1 or PRI lines to specific outgoing
channels on the same or different T1 or PRI lines. To implement MAXDAX, you must set
parameters in the Net2Net Incoming Calls and Net2Net ChanGroup ID profiles. In the
Net2Net Incoming Calls profile, you define parameters used in configuring channels on which
the MAX unit receives incoming calls. In the Net2Net ChanGroup ID profile, you define
parameters used in configuring channels for outbound calls.
For complete information about MAXDAX, see "Configuring MAXDAX" on page 3-73. Or,
for detailed information about each parameter, see the MAX Reference.
Following are the parameters you set in the Net/T1 > Line Config profile > Line N > Net2Net
Incoming Calls profile:
Parameter
3-10
Allows the PRI-T1 conversion process to use number (one or two) of sets
of Goertzel samples the PRI-T1 conversion process is to use for DTMF
tone detection. By default, the MAX uses only one sample to decode
signals from robbed-bit PBXs, because some PBX devices have a tone
duration of less than 50ms, which does not provide enough time to
compute two sets of Goertzel samples. The PRI-T1 conversion process is
more accurate when the MAX can use two samples. Using two samples is
recommended when the tone duration is longer than 70ms.
Specifies
Service provider's call-by-call signaling value for routing calls from a
local device to the carrier's network through the MAX unit.
TypeOfNumber field in the called party's information element.
Specifies
MAX 6000/3000 Network Configuration Guide