At Command Set And S-Registers; Overview; Operating Modes - Paradyne COMSPHERE 3910 Installation And Operation Manual

3900 series point-to-point/multipoint modems
Hide thumbs Also See for COMSPHERE 3910:
Table of Contents

Advertisement

AT Command Set and S-Registers

Overview

The AT command set provides an alternative method to the modem's DCP for entering commands
that control the operation and configuration of the 391x Series modems. This chapter discusses
guidelines necessary to operate AT commands as well as listing the modifiers for all AT commands
supported by the 391x Series modems. AT commands are issued from asynchronous DTEs.

Operating Modes

The 391x Series modem has two operating modes, Command mode and Data mode. Before a
modem goes online (establishes a successful connection with a remote modem), it is considered to
be in Command mode; an idle state where you can modify its operating parameters or issue
modem commands. (Any command issued is acknowledged with a response in either words or
digits known as Result Codes. Refer to Table 5-1 for a listing of result codes.)
Once the modems are online, either by answering or originating a call, they automatically switch to
Data mode. Data mode is a state where any entries made from the DTE are considered data and are
transmitted and received between modems. The modems remain in Data mode until the connection
is broken or until they are forced into online Command mode using the escape sequence.
Switching Between Data Mode and Online Command Mode
Sometimes it is necessary to change operating parameters while the modems are online. The
Escape Sequence allows you to toggle the modem between Data mode and online Command mode
while maintaining a connection with the remote modem. This is accomplished using the escape
sequence ( + + + ) to exit Data mode and the O command to return to Data mode.
3910-A2-GN32-30
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operating Modes
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Switching Between Data Mode and Online Command Mode
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
November 1996
5-1
5-1
. . . . . . . . .
5-1
. . . . . . . . . . . . . . . . . . . . . .
5-2
5-2
5-3
5-4
5-4
5-14
5-15
5
5-1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Comsphere 3911

Table of Contents