Security Branch; Manual Dialing When The Remote Modem Is Configured For Manual Answer - Paradyne COMSPHERE 3910 Installation And Operation Manual

COMSPHERE 3900 Series Modems

Manual Dialing When the Remote Modem is Configured for Manual Answer

If you are originating a call using a telephone and the remote modem is configured for Manual
Answer, perform the following procedure.
Once the remote telephone is answered by the remote user, you must both decide when to place the
modems into Data mode. You must both select Tlk/Data at approximately the same time and hang
up the handset to begin the handshaking sequence.
If the handshake is successful, the modems are in Data mode and OnLine appears on the LCD.
Once the modems are online, the status messages listed in Table 3-3 appear on the Top-Level
display.
It is not necessary to specify an originating or answering modem when dialing via the DCP
because the answering modem detects that it is receiving a ringing voltage and automatically
defaults to Answer mode.

Security Branch

The Security branch allows you to create, edit, and save parameters that determine how the
modem's security is executed. For security procedures and configuration options, refer to
Chapter 6, Dial Access Security.
3-64
On both modems, the Line Current Disconnect configuration option
(refer to the Line Dialer section in Chapter 4) must be set to Disable
This configuration option does not appear on Models 3910-A1-401
and 3911-B1-001.
If the remote modem is not a 3900 Series modem, then the remote
user must consult that modem's operator's manual to perform a
similar operation.
November 1996
NOTE
NOTE
.
3910-A2-GN32-30