Paradyne COMSPHERE 3910 Installation And Operation Manual page 178

COMSPHERE 3900 Series Modems
S-Register
S82 V.32bis Autorate (Leased Line). Register determines if Autorating is
used on leased lines when connected in V.32bis mode.
Register has the following values:
0 = Enable
1 = Disable
The factory setting is Enable.
S84 AT Command Mode. Register determines how the modem responds to
valid and invalid AT commands.
Register has the following values:
0 = Normal
1 = No ERROR
2 = No Strap or ERROR
The factory setting is Normal.
S85 Fast Disconnect. Register allows the modem to disconnect
immediately after receiving a disconnect command from a local DTE
or its own diagnostic control panel.
Register has the following values:
0 = Disable
1 = Enable
The factory setting is Disable.
S88 Straps When Disconnected. Register determines whether or not
configuration options in the Active (Saved) configuration area are
reloaded to Active (Operating) when a disconnect occurs.
Register has the following values:
0 or 231 = No Change
1 or 232 = Reload
The factory setting is No Change.
5-24
Table 5-4
(10 of 13)
391x Series S-Registers
Description
November 1996
DCP LCD
Command
Sequence
Configure\Edit\
Leased Line
Configure\Edit\
DTE Dialer
Configure\Edit\
Line Dialer
Configure\Edit\
Misc
3910-A2-GN32-30