At Command Set And S-Registers; Gat Commands And S-Registers - Paradyne KeepInTouch 3760 User Manual

AT Command Set and
S Registers
AT Commands and S-Registers
This chapter provides a list of all AT commands and S-Registers
supported by the KeepInTouch Card modem. This chapter first
lists AT commands in alphabetical order followed by S-Registers
listed in numerical order. Factory settings are listed in bold.
In general, AT commands are responsible for instructing the
modem to do a task, while S-Registers are responsible for
determining how the AT command will perform that task. You
issue these commands to your modem via your communications
software. When a modem receives a command, it responds with
a message, known as a result code, that displays on your
monitor. Result codes are described in Appendix C.
For a brief overview of command guidelines, refer to the Using
AT Commands section in Chapter 3, Using Your Modem . For
more detailed information on the commands, refer to the help
text file "atcmds.txt" on the Installation Utilities diskette.
The AT commands and S-Registers supported by the
KeepInTouch Card modem are listed in Table 4-1. The
acceptable values for some AT commands and S-Registers
depend on the country in which your are operating your modem.
For those AT Commands and S-Registers, you will be referred
to Table 4-2 for the acceptable values for your country. Table 4-3
also provides command usage information which varies by
country.
4
Issue 3 April 1994
4-1