Result Codes - Paradyne COMSPHERE 3910 Installation And Operation Manual

Result Codes

Table 5-1 lists all valid result codes for the 391x Series modem.
Numbers Numbers
(1) (2)
0 0
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
10 10
11 11
12 12
13 16
14 13
15 14
16 15
17 17
19 19
20 10
21 11
22 12
23 16
24 13
25 17
* Only appears when the Extended Result Codes configuration option is enabled.
** Only appears when the Extended Result Codes configuration option is set for Use_DTE_Rate. This
displays the DTE data rate instead of the line rate.
*** Only appears when the Extended Result Codes configuration option is set for Add/EC. If this
configuration option is set for Add/V42, MNP, then either V42b, V42, MNP5, MNP4, MNP3, MNP2, or
NoEC appears.
3910-A2-GN32-30
Table 5-1
(1 of 2)
Result Codes
Word
OK
CONNECT
RING
NO CARRIER
ERROR
CONNECT 1200*
NO DIALTONE*
BUSY*
NO ANSWER*
CONNECT 2400*
CONNECT 4800*
CONNECT 9600*
CONNECT 12000*
CONNECT 14400*
CONNECT 19200**
CONNECT 7200*
CONNECT 16800**
CONNECT 300*
CONNECT 2400/ EC***
CONNECT 4800/ EC***
CONNECT 4800/ EC***
CONNECT 12000/ EC***
CONNECT 14400/ EC***
CONNECT 16800/ EC**
November 1996
Description
Command executed
Modem connected to line
Modem receiving a ring voltage from the VF line
Modem lost carrier signal, does not detect carrier
signal, or does not detect answer tone
Invalid command
Connection at 1200 bps
No dial tone detected
Busy or trunk busy signal detected
No "quiet" answer (@)
Connection at 2400 bps
Connection at 4800 bps
Connection at 9600 bps
Connection at 12,000 bps
Connection at 14,400 bps
Connection at 19,200 bps
Connection at 7200 bps
Connection at 16,800 bps
Connection at 300 bps
Connection at 2400 bps with error control
Connection at 4800 bps with error control
Connection at 4800 bps with error control
Connection at 12,000 bps with error control
Connection at 14,400 bps with error control
Connection at 16,800 bps with error control
AT Command Set and S-Registers
5-3