Paradyne COMSPHERE 3910 Installation And Operation Manual page 160

COMSPHERE 3900 Series Modems
AT
Command
D n (cont.) @
!
;
Space — Ignored by the dial string, can be included to enhance
–
( )
DS= n Dial Stored Number. Dials the number stored in Location n (1–24). (To
store a telephone number, refer to the & Zn=x command.)
E n Command Character Echo.
E0 Disables echo to the DTE.
E1 Enables echo to the DTE.
H n Hook Switch Control.
H0 Modem goes on-hook.
H1 Modem goes off-hook.
I n
Identification.
I0 Displays product code — 144.
1 Displays 3-digit firmware revision number.
Performs an EPROM check.
I2
L n Speaker Volume.
L0 Selects low volume.
L1 Selects low volume.
L2 Selects medium volume.
L3 Selects high volume.
M n
Speaker On/Off.
M0 Speaker always OFF.
M1 Speaker ON until carrier signal is detected.
M2 Speaker always ON.
5-6
Table 5-2
(2 of 3)
391x Series AT Commands
Description
— Quiet answer. Wait for five seconds of silence after dialing
the number. If the silence is not detected, the modem
sends either a NO ANSWER result to the DTE.
— Hook flash. This causes the modem to go on-hook for 0.5
seconds then return to off-hook.
— Return to Command mode. Modem returns to Command
mode after dialing a number without disconnecting the call.
readability.
— Ignored by the dial string, can be included to enhance
readability.
— Ignored by the dial string, can be included to enhance
readability.
November 1996
DCP LCD
Command
Sequence
Call Setup\Dial\
Dial Directory:
Configure\Edit\
DTE Dialer
H0: Call Setup\
Disconnect or
Control\Remove
Make Busy
H1: Control\
Make Busy
Status\Identity
Control\Speaker
Configure\Edit\
Misc
Control\Speaker
Configure\Edit\
Misc
3910-A2-GN32-30