Talk/Data Branch - Paradyne COMSPHERE 3910 Installation And Operation Manual

COMSPHERE 3900 Series Modems
Select Nxt to display other directory locations.
The status of a directory location can be:
No Number
Allowed
Delayed
Forbidden
Delayed and Forbidden only appear in certain countries.
When a number is delayed, press the
The delayed and forbidden conditions can be cleared by power cycling the modem. This is actually
the only way to reenable a forbidden number. Deleting a number from a directory location and
reentering it into another directory location will not change the delayed or forbidden condition of
this number.

Talk/Data Branch

The Talk/Data function is not available in TMp Control mode.
The Talk/Data branch of the Top-Level menu allows you to switch the modem between Talk mode
and Data mode when manually dialing using either the DCP or an externally attached telephone.
To add an external telephone to your modem, use an external "Y" cable to connect the phone line
to both the modem and the telephone (refer to Appendix C). This cable is not supplied with your
modem.
On initial power-up, the modem is in Talk mode. When in Talk mode, the modem is disconnected
and you are free to use the telephone. When in Data mode, the modem is connected and data can
be transmitted or received. This function is not available for Model 3911 modems.
Status Configure
3-62
Number Status
Nxt 01:Allowed
F1 F2
The directory location is empty.
The number in this directory location may be dialed at this time.
The number in this directory location may be dialed later.
The number in this directory location may not be dialed.
PList Control Test
November 1996
F3
key to display the value of the delay in minutes.
"Status"
SubHS Call_Setup
Tlk/Data
Security Remote
3910-A2-GN32-30