Paradyne COMSPHERE 3910 Installation And Operation Manual page 45

Status
Call Failure No Dial–DTR
Cont.
No Dial–Test
No Dial Tone
No Quiet
Answer
Ringback
Timeout
Trunk Busy
Wrong Call
Call Disconnect ATH Disconnect
Bad Lines Disc
No Carrier Disc
DTR
Disconnect
EC Disconnect
Inv Rate Disc
LnCurrnt Disc
LongSpace
Disc
NoData Disc
Disconnecting
RmtCmnded
Disc
Talk Mode
Firmware DownldOnly
Download Mode
Result
Frmware
Upgrade
RemClone
Failed
3910-A2-GN32-30
Top-Level Menu Status
Message
The modem cannot dial because DTR is OFF.
The modem cannot dial because it is running a Test.
The modem has aborted the call because it cannot detect a dial
tone.
The modem has detected No Quiet Answer (@) before the time-out
setting of the No Answer Disconnect configuration option.
The answering modem did not answer within the time limit specified
by the No Answer Timeout configuration option. A ringback signal
was detected.
The modem is receiving a fast (trunk) busy.
The call was answered, but not by a modem. No answer tone.
The modem has disconnected due to an ATH command.
The modem has disconnected because the lines do not support the
modulation and/or data rate selected.
The modem disconnects due to the loss of carrier signal from the
remote modem.
The modem has disconnected due to the loss of DTR from the DTE.
The modem has disconnected due to failure to negotiate Error
Control mode.
When using V.32bis modulation, the remote modem does not
support the data rate used by the local modem.
The modem has disconnected due to the loss of line current.
The modem has disconnected due to the detection of a long space.
The modem has disconnected due to a lack of transmitted and
received data.
The modem has begun the disconnect sequence.
The modem has disconnected due to a V.32 Cleardown received
from the remote modem.
The modem is in Talk mode.
A local download of firmware or a remote cloning of firmware has
failed. The modem is currently in a Download Only mode in which
only another download attempt is possible.
A local download of firmware or a remote cloning of firmware was
successful.
A remote cloning of firmware has failed. This message appears on
the local modem's LCD.
November 1996
Table 3-3
(3 of 4)
Indicates
DCP Operation
3-11