Paradyne COMSPHERE 3910 Installation And Operation Manual page 162

COMSPHERE 3900 Series Modems
AT
Command
X n Extended Result Code, Dial Tone Detect, and Busy Tone Detect
Configuration Options.
Extended Result Code:
Enable
Disable
Add/EC
Add/V42,MNP Displays result codes with V.42 or MNP suffix.
Use DTE Rate Displays DTE data rate instead of line rate.
Dial Tone Detect:
Enable Enable
Disable
NOTE: It may not be possible to disable Dial Tone Detect in some
countries.
Busy Tone Detect:
Enable
Disable
Y n Long Space Disconnect.
Y0 Disable. Ignores long space.
Y1 Enable. Disconnects if long space is detected. Enables
transmission of a long space.
5-8
391x Series AT Commands
Description
Extended
Result Code:
X0 Disable
X1 Enable
X2 Enable
X3 Enable
X4 Enable
X5 Add/EC
X6 Add/V42.MNP
X7 Use DTE Rate
Displays all result codes listed in Table 5-1 except for
error control suffix.
Only displays OK, CONNECT, RING, NO CARRIER,
ERROR ERROR.
Displays result codes with /EC suffix.
Sets the modem for dial tone detect Sets the modem for dial tone detect.
Sets the modem for blind dialing.
Modem monitors for busy tone.
Modem ignores busy tone.
November 1996
Table 5-3
(2 of 8)
Dial Tone Busy Tone
Detect: Detect:
Disable Disable
Disable Disable
Enable Disable
Disable Enable
Enable Enable
Enable Enable
Enable Enable
Enable Enable
DCP LCD
Command
Sequence
Extended
Result Code:
Configure\Edit\
DTE Dialer
Dial Tone
Detect:
Configure\Edit\
Line Dialer
Busy Tone
Detect:
Configure\Edit\
Line Dialer
Configure/Edit/
Line Dialer
3910-A2-GN32-30